Skip to main content
Your store address is shown to customers, sets the map pin storekit uses for distance calculations, and is printed on invoices. You set it on the General settings page.

​
Set or Change Your Address

1

Open General settings

Go to Stores → your store → Settings → General.
2

Edit the address

Under Store address, click Edit and fill in the fields listed below.
3

Close the form

Click Done. This closes the form but does not save it.
4

Save

Click Save in the bar at the top of the page. Click Discard instead to undo your changes.

​
Address Fields

​
The Map Pin

When you save, storekit looks up the address with Google Maps and places the pin from the result. The map above the address shows that pin. After you change the address, the map shows Pin updates on save until you save. There is no draggable pin and no way to enter coordinates in the dashboard. The pin always comes from the address text. If Google Maps cannot find the address, the address still saves but the pin stays where it was. If the pin is in the wrong place after saving, correct the address fields and save again.

​
Show the Address to Customers

The Visible to customers switch (Show address on your store before ordering) controls whether customers see the address. It appears only when the store offers pickup or delivery. When it is on, the address appears in the store information on your ordering site, in the store list and store map on brand pages, and on the order status page. Turning it off hides the address from customers. The pin is still used for distances.

​
Where the Pin Is Used

Changing the address affects delivery zones differently by type. Driving distance zones are measured by road from the store address, so they follow the new address. Circle and Polygon zones keep the position they were drawn with and do not move. If you move your store, check your zones in Delivery Zones and redraw any circle or polygon zones.